Delta Servo Drive Programming Cable ASDA-B2/AB

Description

To program and configure Delta Servo Drive Programming Cable ASDA-B2/AB, a specific programming cable is needed to connect the servo drive to a PC. Here’s the information you need regarding the programming cable for the Delta ASDA-B2/AB series: If you want to ASDA-B2/AB price in Bangladesh You can contact BAT Power Solution.

Delta Servo Drive Programming Cable ASDA-B2/AB are Given Below

1. Cable Model:
   • The standard programming cable used for Delta ASDA-B2/AB servo drives is usually referred to as the ASDA-B2/AB Programming Cable or simply the Delta Servo Drive Programming Cable.
2. Cable Type:
   • This cable typically uses RS-232 or USB communication depending on the model and specific requirements.
3. Connector Types:
   • For RS-232 connections, the cable may have:
     • A DB9 connector for the PC’s serial port.
     • A specific connector for the Delta servo drive side.
   • For USB connections, the cable usually has:
     • A USB Type-A connector for the PC.
     • A connector compatible with the Delta servo drive’s programming port.
4. Use Case:
   • The cable is used to connect the Delta ASDA-B2/AB servo drives to a PC for programming, configuration, monitoring, and diagnostics using the appropriate software.
   • This is essential for setting parameters, tuning the servo motor, and monitoring its performance.
5. Cable Length:
   • The length of the programming cable is generally around 2 to 3 meters, which is typical for most industrial applications.

Programming Software

• Delta Motion Control Software (DMC):
  • Use Delta’s DMC software to program and configure the ASDA-B2/AB servo drives. This software provides a user-friendly interface for setting parameters, tuning, and monitoring the drive’s performance.

Installation and Connection Instructions

1. Connect the Cable:
   • For RS-232:
     • Connect the DB9 connector to the PC’s serial port.
     • Connect the other end of the cable to the servo drive’s programming port.
   • For USB:
     • Connect the USB Type-A connector to the PC.
     • Connect the appropriate connector to the servo drive.
2. Driver Installation:
   • If using a USB cable, ensure any necessary drivers are installed. These can typically be found on the Delta Electronics website.
3. Configure Communication Settings:
   • Open DMC software and select the correct COM port corresponding to the connection.
   • Configure the communication parameters (baud rate, etc.) based on the servo drive’s requirements.
4. Start Programming:
   • With the connection established, you can begin programming and configuring the Delta ASDA-B2/AB servo drives using the DMC software.

Summary

The programming cable for Delta ASDA-B2/AB servo drives is essential for connecting the drive to a PC for configuration and monitoring. Depending on your setup, you may use either an RS-232 or USB cable, along with Delta’s DMC software for programming.

Others Products