CA3-CBLQ-01 Proface HMI to Mitsubishi Q PLC Cable

The CA3-CBLQ-01 Proface HMI to Mitsubishi Q PLC Cable is specifically used for communication between a Pro-face HMI and a Mitsubishi Q Series PLC. This cable allows the HMI to interface with the PLC for data transfer, control, and monitoring, enabling communication between the two devices without requiring complex wiring setups. If need CA3-CBLQ-01 cable you can contact BAT Power Solution Via Email/Call/WhatsApp

Key Features CA3-CBLQ-01 Proface HMI to Mitsubishi Q PLC Cable

• Pro-face to Mitsubishi Q PLC Interface: Facilitates communication between Pro-face HMI units and Mitsubishi Q series PLCs.
• Plug-and-Play Connection: Simplifies setup by directly connecting the HMI to the PLC for seamless data transfer.
• High Reliability: Ensures stable data communication, making it suitable for industrial environments where HMI and PLC interaction is critical.

others cable

Cable Specifications

1. Pro-face HMI End:
   • The connector at the HMI end of the cable is designed to fit into the communication port of compatible Pro-face HMI models, typically an RS232 or RS422/RS485 port, depending on the HMI model.
2. Mitsubishi Q PLC End:
   • The PLC end of the cable connects to the communication port on the Mitsubishi Q Series PLC (usually via RS232 or RS422), depending on the specific PLC model.
3. Communication Protocol:
   • Supports RS232 or RS422/485 communication protocols, enabling data exchange between the HMI and PLC for control, monitoring, and data logging purposes.

Connection Setup CA3-CBLQ-01 Proface HMI to Mitsubishi Q PLC Cable

1. Connect the Pro-face End of the CA3-CBLQ-01 cable to the communication port on the Pro-face HMI.
2. Connect the Mitsubishi Q PLC End to the corresponding communication port on the Mitsubishi Q Series PLC.
3. Open GP-Pro EX, the Pro-face HMI software, and ensure the correct communication settings are configured (baud rate, parity, stop bits, etc.).
4. Set up the communication protocol (e.g., RS232 or RS422/485) and verify the HMI is properly communicating with the PLC.
5. Once connected, you can monitor and control the PLC from the HMI, transfer data, or update settings in real-time.

Supported Pro-face HMI Models

• Pro-face GP Series HMIs:
  • GP3000 Series (e.g., GP3400, GP3500, GP3600)
  • GP4000 Series (e.g., GP4301T, GP4401T, GP4501T)

Supported Mitsubishi Q PLC Models

• Mitsubishi Q Series PLCs:
  • Models like Q00J, Q01, Q02, Q06H, Q25H, and other Mitsubishi Q Series PLC models.

Software Used Proface HMI to Mitsubishi Q PLC Cable

• GP-Pro EX: Pro-face’s official HMI software that allows programming and configuration of HMI and PLC interactions. It enables communication setup between the HMI and PLC and allows for real-time monitoring and control of PLC processes.

Important Notes

• Verify Compatibility: Ensure that both the HMI and PLC support the communication method you are using (e.g., RS232 or RS422/RS485).
• Communication Settings: Match the baud rate, parity, and data bits settings on both the HMI and the PLC for successful communication.
• Driver Installation: If required for USB conversion, make sure to install any necessary drivers for the cable.